Results 1 to 2 of 2

Thread: Cannot change flight modes

  1. #1

    Question Cannot change flight modes

    I have tried all potential ways and how they are listed in the manual/forums to change the flight modes without success.

    "Switching between flight modes
    1) Install flight battery into your RC EYE One S and connect the battery. The RC EYE’s status LED should go
    solid green.
    2) Make sure that the throttle stick is at full zero. Turn on your TX. The RC EYE’s status LED should start to
    flash either, green, orange or red, depending on its last known flight mode. To change the flight mode
    press the ‘MODE button’ twice until you hear a beep sound. One beep indicates that you are in BEGINNER
    mode (green flashing LED), two beeps indicate that you are in SPORT mode (orange flashing LED) and 3
    beeps indicate that you are in EXPERT mode (red flashing LED)."

    Is there another way than listed in the manual or a trick?

    Regards,
    KalleH

  2. #2
    Quote Originally Posted by kalleh View Post
    I have tried all potential ways and how they are listed in the manual/forums to change the flight modes without success.

    "Switching between flight modes
    1) Install flight battery into your RC EYE One S and connect the battery. The RC EYE’s status LED should go
    solid green.
    2) Make sure that the throttle stick is at full zero. Turn on your TX. The RC EYE’s status LED should start to
    flash either, green, orange or red, depending on its last known flight mode. To change the flight mode
    press the ‘MODE button’ twice until you hear a beep sound. One beep indicates that you are in BEGINNER
    mode (green flashing LED), two beeps indicate that you are in SPORT mode (orange flashing LED) and 3
    beeps indicate that you are in EXPERT mode (red flashing LED)."

    Is there another way than listed in the manual or a trick?

    Regards,
    KalleH
    Hey KalleH,

    Hopefully we can get you up and going quickly on switching flight modes.

    When you turn the transmitter on are you getting the flash on the top led or is it staying solid green?

    Also pressing the button twice is probably better described as a quick double tap of the mode button.

    You should see the LED change and also here the audible beeps. However this won't work if the LED on top of the unit is solid. This would mean you need to rebind.

    Let me know if any of this helps or works.

    Regards,
    Jamie

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •